amiga-news DEUTSCHE VERSION
.
Links| Forums| Comments| Report news
.
Chat| Polls| Newsticker| Archive
.

[Login] [Register] [Forgot your password??]

< Next messagePrior message >
04.Apr.2014



3D print: Minimig-case in A1000-design available (Update)
Last year, Thomas 'Tommes' Koch introduced the prototype of a case for the Amiga clone Minimig which should be created in 3D print. Meanwhile two other prototypes has been created - the third prototype shown below can be ordered from the 3D service provider Shapeways :



According to Koch it might be necessary to rework the notches for the LEDs of the case. Apart from that the case was very well done and can be put together without any screws.

If there will be enough interested persons, Koch will organize a collective order for painting the cases. First he is going to paint one of his prototypes with the colours of an Amiga 1000 and publish pictures of them.

Update: (07:33, 06.04.14, snx)
As Thomas Koch informed us, the case has been updated. The version available in the shop is "Mark-III Revision 6". (cg) (Translation: dr)

[News message: 04. Apr. 2014, 01:29] [Comments: 0]
[Send via e-mail]  [Print version]  [ASCII version]
< Next messagePrior message >

.
Masthead | Privacy policy | Netiquette | Advertising | Contact
Copyright © 1997-2019 by amiga-news.de - all rights reserved.
.